EIA-422 - significado y definición. Qué es EIA-422
Diclib.com
Diccionario ChatGPT
Ingrese una palabra o frase en cualquier idioma 👆
Idioma:

Traducción y análisis de palabras por inteligencia artificial ChatGPT

En esta página puede obtener un análisis detallado de una palabra o frase, producido utilizando la mejor tecnología de inteligencia artificial hasta la fecha:

  • cómo se usa la palabra
  • frecuencia de uso
  • se utiliza con más frecuencia en el habla oral o escrita
  • opciones de traducción
  • ejemplos de uso (varias frases con traducción)
  • etimología

Qué (quién) es EIA-422 - definición

STANDARD FOR SERIAL COMMUNICATION
Rs 422; Rs422; RS 422; RS422; TIA-422; EIA-422
  • Data rate versus line length chart, from RS-422 Annex A.1
  • RS-422 network with multiple receivers

EIA-422         
<communications, standard> (Formerly "RS-422") An EIA serial line standard which specifies 4-wire, full-duplex, differential line, multi-drop communications. The mechanical connections for this interface are specified by EIA-449. The maximum cable length is 1200m. Maximum data rates are 10Mbps at 1.2m or 100Kbps at 1200m. EIA-422 cannot implement a truly multi-point communications network (such as with EIA-485), although only one driver can be connected to up to ten receivers. The best use of EIA-422 is probably in EIA-232 extension cords. {Comparing EIA-422, 423, 449 to RS-232-C (http://rad.com/networks/1995/rs232/rs449.htm)}. {Details on RS-232, 422, 423 and 485 (http://rs485.com/rs485spec.html)}. (2002-10-05)
RS-422         
RS-422         
RS-422, also known as TIA/EIA-422, is a technical standard originated by the Electronic Industries Alliance that specifies electrical characteristics of a digital signaling circuit. It was intended to replace the older RS-232C standard with a standard that offered much higher speed, better immunity from noise, and longer cable lengths.

Wikipedia

RS-422

RS-422, also known as TIA/EIA-422, is a technical standard originated by the Electronic Industries Alliance that specifies electrical characteristics of a digital signaling circuit. It was meant to be the foundation of a suite of standards that would replace the older RS-232C standard with standards that offered much higher speed, better immunity from noise, and longer cable lengths. RS-422 systems can transmit data at rates as high as 10 Mbit/s, or may be sent on cables as long as 1,200 meters (3,900 ft) at lower rates. It is closely related to RS-423, which uses the same signaling systems but on a different wiring arrangement.

RS-422 specifies differential signaling, with every data line paired with a dedicated return line. It is the voltage difference between these two lines that define the mark and space, rather than, as in RS-232, the difference in voltage between a data line and a local ground. As the ground voltage can differ at either end of the cable, this required RS-232 to use signals with voltage magnitudes greater than 5 volts. Moving to dedicated return lines and always defining ground in reference to the sender allows RS-422 to use 0.4 V, allowing it to run at much higher speeds. RS-423 differs primarily in that it has a single return pin instead of one for each data pin.